Knowledge Base

Why am I prompted to insert media into slot "X" after using the import command with a Dell PowerVault 122T DLT VS80 Autoloader tape drive? - Technical Tip - 132733


Import (insert) a cartridge using the Operator Control panel on the front panel of the tape drive.

When using a Dell PowerVault 122T DLT VS80 and issuing an import command from the backup software, an informational screen appears indicating that media can now be added to the autoloader in slot "x".

NOTE:

The inject command is used in the Microsoft® Windows® 2000 native backup application.

Import (insert) a cartridge using the Operator Control panel on the front panel of the tape drive. Once the cartridge is imported, respond to the application by clicking OK.

NOTE:

For more information on using the Operator Control Panel on the PowerVault 122T, refer to the Operating the Autoloader sectino of the User''s Guide located at: http://docs.us.dell.com/docs/stor-sys/122T/en/ug/index.htm




 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

ID articolo: SLN49247

Data ultima modifica: 11/14/2010 12:00 AM


Valuta questo articolo

Preciso
Utile
Facile da comprendere
Questo articolo ti è stato d'aiuto?
No
Inviaci un feedback
I commenti non possono contenere i seguenti caratteri speciali: <>() \
Spiacenti, il sistema di feedback al momento non è attivo. Riprova più tardi.

Grazie per il tuo feedback.