Knowledge Base

046-310: IOT HVPS Error

MCU detected the HVPS error.

1. Cycle power on the Printer.
   1. Turn the printer off.
   2. Wait 10 seconds.
   3. Turn the printer on.
   4. Determine if the issue still occurs.
      
      
2. If the error persists, replace the HVPS.
   • If the HVPS has already been replaced, replace the MCU.
   • If the MCU has already been replaced, replace the Printer.

---

 

Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.