Knowledge Base

Precision T3600 or T5600 No BOOT after HDD or SATA Cable replacement





The Precision T3600/T5600 Workstation may experience a No BOOT issue after the hard drive or SATA Cable is replaced for other issues. Follow the guidelines provided in this article to resolve the issue.


No BOOT after drive or cable replacement.

The Precision T3600/T5600 Workstations may encounter a No BOOT issue after replacement of the Boot Hard Drive or the Boot Hard Drive SATA cable.


Ensure cable properly connected.

This issue often occurs when the SATA cable is not connected to the correct port on the motherboard.

Ensure the hard drive is connected to the Blue SATA connector marked HDD0 (Figure 1):

Figure 1: Connect the hard drive to the blue SATA connector marked HDD0

NOTE: This does not apply to RAID configurations or systems with expansion HDD controllers.

If you need further assistance troubleshooting this issue, please contact Dell Technical Support.




ID articolo: SLN301313

Data ultima modifica: 03/05/2018 09:33 AM


Valuta questo articolo

Preciso
Utile
Facile da comprendere
Questo articolo ti è stato d'aiuto?
No
Inviaci un feedback
I commenti non possono contenere i seguenti caratteri speciali: <>() \
Spiacenti, il sistema di feedback al momento non è attivo. Riprova più tardi.

Grazie per il tuo feedback.