Knowledge Base

Why Is the Custom Wallpaper Missing on My Dell (PRODUCT) RED Computer? - KB Article - 340283




(PRODUCT) RED Customizations are Overwritten by Dell DataSafe PC-to-PC Transfer

On (PRODUCT) RED computers that were ordered with Dell DataSafe PC-to-PC Transfer, the (PRODUCT) RED customizations are replaced by the wallpaper and other custom settings from the old computer.

To reapply the (PRODUCT) RED custom settings, perform the following steps:

  1. Click Start, and then click then click Computer.

  2. Double-click the icon for you hard drive, usually labled Local Disk (C:).

  3. Double-click the Dell folder.

  4. Double-click the Red folder.

  5. Double-click the Recovery folder.

  6. Right-click Setup and select Run as administrator.

  7. In the Open File - Security Warning window click Run.

After the program is finished all (PRODUCT) RED custom settings should be restored.



 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: SLN39638

Last Date Modified: 08/26/2010 12:00 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.