ナレッジベース

How to Replace the Fuser and Reset the Life Counter on 5330dn Dell Laser Printers


Table of Contents:

  1. Obtain Replacement Fuser
  2. Fit Replacement Fuser
  3. Reset Fuser Life Counter

This article provides information on "How to Replace the Fuser and Reset the Life Counter on 5330dn Dell Laser Printers"


1. Obtain Replacement Fuser

Fuser units at end of life may be covered by warranty. Please contact Dell Technical Support to check the warranty terms in your region.

More info can be found in the 5330dn User’s Guide.

Back to Top

2. Fit Replacement Fuser

Caution: The fuser unit reaches very high temperatures in normal use. Always allow the fuser to cool before handling.

To fit the replacement fuser:

  1. Remove the duplex unit.

  2. Open the rear door.

  3. Twist the top of the blue plastic strap on the left hand side to unhook it from the printer chassis.

  4. Lay the back door fully horizontal then lift on the right hand side to remove.

  5. If present remove the retention screws circled below. Do not remove the screw for the fuser grounding wire. Retention screws may not always be present.

  6. Push the blue plastic retention clips towards the centre of the fuser unit to unlock it.

  7. Remove the fuser unit.

  8. Remove all packaging from replacement fuser, follow previous steps in reverse order to fit.

More info can be found in the 5330dn User’s Guide.

Back to Top

3. Reset Fuser Life Counter

To reset the life counter:

  1. Enter the printer's Tech Mode by quickly pressing the sequence of keys Menu > Up Arrow > Left Arrow > Tick > Right Arrow > Cancel > Menu. If Tech Mode doesn't appear, press the key sequence again as quickly as possible. A delay in pressing the keys will stop the menu from opening.
  2. Select Tech Menu > Data Setup > Clear Fuser Count.
  3. Restart the printer.

More info can be found in the 5330dn User’s Guide.

If these steps do not correct the problem, please contact Dell Technical Support.

Back to Top



記事ID: SLN153531

最終更新日: 08/19/2015 05:09 PM


この記事を評価する

正確
有益
分かりやすい
この記事は役に立ちましたか?
はい いいえ
フィードバックをお寄せください
コメントでは、以下の特殊文字は利用できません: <>()\
申し訳ありませんが、フィードバックのシステムは現在ご利用いただけません。後でもう一度試してください。

フィードバックをありがとうございます。