ナレッジベース

How to assign services to a New Exchange Certificate in Exchange 2010 through Exchange Management Console



Article Summary: This article provides information about How to assigning services to a New Exchange Certificate in Exchange 2010 through Exchange Management Console


In the console tree, select Server Configuration.

In the action pane, click Assign Services to Certificate to open the Assign Services to Certificate wizard.

This wizard helps you assign the appropriate services to your certificate for your Exchange organization.

On the Assign Services page, use the check boxes in the Assign Services section to choose the services you want to assign to your certificate. If you chose services during certificate creation, these services will already be checked. Click Assign.

On the Completion page, verify that all of the services were assigned properly.

If you attempt to assign the Unified Messaging service to the certificate and the certificate is running in TCP mode only, assignment will fail. In order to use a certificate for Unified Messaging, it must be set to run in TLS mode or Dual mode.




Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

記事ID: SLN286103

最終更新日: 10/29/2014 10:41 AM


この記事を評価する

正確
有益
分かりやすい
この記事は役に立ちましたか?
はい いいえ
フィードバックをお寄せください
フィードバック内に無効な文字が含まれています。以下の特殊文字は利用できません <> ( ) &#92;
申し訳ありませんが、フィードバックのシステムは現在ご利用いただけません。後でもう一度試してください。

ご協力ありがとうございます。フィードバックが送信されました。