ナレッジベース

024-362 IOT Start Image Marking Time-out Error on the Dell 2155cn/cdn Laser Printer


Article Summary: This article provides Information on 024-362: IOT Start Image Marking Time-out Error on the Dell 2155cn/cdn Laser Printer


Table of Contents:
  1. 024-362: IOT Start Image Marking Time-out Error on the Dell 2155cn/cdn Laser Printer



1.

024-362: IOT Start Image Marking Time-out Error on the Dell 2155cn/cdn Laser Printer


  1. Turn off the Printer and remove the communication cables (USB or Ethernet, depending on Set-Up)


  2. Power the Printer on and Print a System Settings Report


  3. If the error recurs download the latest Firmware from the Dell Support Site


  4. NOTE: Do Not turn off the Printer while the Firmware update is being applied as it may damage the controller card in the Printer, follow the on-screen instructions carefully.

  5. Print another System Settings Report and verify if error has recurred


  6. If the error has recurred, please contact Dell via the Twitter button, to advise of a technical fault

Back to Top

If you require further assistance or wish to give us feedback, please engage our technical team on Twitter.

 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

記事ID: SLN286266

最終更新日: 05/11/2016 12:49 PM


この記事を評価する

正確
有益
分かりやすい
この記事は役に立ちましたか?
はい いいえ
フィードバックをお寄せください
フィードバック内に無効な文字が含まれています。以下の特殊文字は利用できません <> ( ) &#92;
申し訳ありませんが、フィードバックのシステムは現在ご利用いただけません。後でもう一度試してください。

ご協力ありがとうございます。フィードバックが送信されました。