ナレッジベース

Latitude XT2: Removal guide for the Battery, SIM card, Bluetooth Module and Hard drive


Article Summary: This article provides information on removing components from a Latitude XT2


Table of Contents:
  1. Battery
  2. SIM Card
  3. Bluetooth Module
  4. Hard Drive




1

Battery



1. Pre-Removal Instructions Before removing the Battery:
  • During installation or removal of any hardware always ensure all data is backed up properly

  • Disconnect any telephone, network, or USB cables from the computer

  • Disconnect the computer and all attached devices from their electrical outlets


2. Slide the two battery-bay latch releases on the bottom of the Tablet-PC outward to each side.




3. Slide the battery out of the battery bay.




4. Remove the battery from the system.




5. Battery removed.






Back to Top






2

SIM Card



1. Pre-Removal Instructions Before removing the SIM Card:
  • During installation or removal of any hardware always ensure all data is backed up properly

  • Disconnect any telephone, network, or USB cables from the computer

  • Disconnect the computer and all attached devices from their electrical outlets

  • Remove the battery


2. Establishing image.




3. Press in on the SIM card and release.




4. Slide the SIM card out of the system.




5. Complete.





Back to Top






3

Bluetooth Module



1. Pre-Removal Instructions Before removing the Bluetooth Module:
  • During installation or removal of any hardware always ensure all data is backed up properly

  • Disconnect any telephone, network, or USB cables from the computer

  • Disconnect the computer and all attached devices from their electrical outlets

  • Remove the battery


2. Establishing image.




3. Loosen the captive screw holding the Bluetooth module in place.




4. Carefully lift the Bluetooth assembly out of the system.




5. Disconnect the Bluetooth cable from the Bluetooth.




6. Remove the Bluetooth assembly from the system.




7. Complete.





Back to Top






4

Hard Drive



1. Pre-Removal Instructions Before removing the Hard Drive:
  • During installation or removal of any hardware always ensure all data is backed up properly

  • Disconnect any telephone, network, or USB cables from the computer

  • Disconnect the computer and all attached devices from their electrical outlets

  • Remove the battery


2. Establishing image.




3. Loosen the four captive screws on the hard drive bracket.




4. Remove the hard drive bracket.




5. Slide the hard drive towards the edge of the system to disconnect from the system board.




6. Remove the hard drive from the system.




7. Complete.





Back to Top


Return to the Latitude XT2 Teardown/Removal Index.






If you require further assistance or wish to give us feedback, please engage our technical team on Twitter.


 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

記事ID: SLN291268

最終更新日: 04/09/2014 12:00 AM


この記事を評価する

正確
有益
分かりやすい
この記事は役に立ちましたか?
はい いいえ
フィードバックをお寄せください
コメントでは、以下の特殊文字は利用できません: <>()\
申し訳ありませんが、フィードバックのシステムは現在ご利用いただけません。後でもう一度試してください。

フィードバックをありがとうございます。