ナレッジベース

How to Troubleshoot Regi Jam (Exit Sensor On JAM) on a S2810dn Dell Laser Printer



Table of Contents:

  1. Troubleshoot Regi Jam (Exit Sensor On JAM)

This article provides information on "How to Troubleshoot Regi Jam (Exit Sensor On JAM) on a S2810dn Dell Laser Printer"


1. Troubleshoot Regi Jam (Exit Sensor On JAM)

Step Action Yes No
1 Ensure that the drum cartridge is installed correctly.
Does this solve your problem?
The task is complete. Go to action 2.
2 Replace the drum cartridge. See "Replacing the Drum Cartridge."
Does this solve your problem?
The task is complete. Go to action 3.
3 Ensure that the fusing unit is set properly.
Does this solve your problem?
The task is complete. Go to action 4.
4 Replace the fusing unit, the transfer unit, and the retard roller.
  1. Replace the fusing unit, the transfer unit, and the retard roller.
    See "Replacing the Fusing Unit, the Transfer Unit, and the Retard Roller."
  2. After you replace the fusing unit, Launch the Tool Box.
  3. Click Chart Print on the Diagnosis tab.
  4. Click Pitch Configuration Chart.
    The Pitch Configuration Chart is printed.
The task is complete. Please contact Dell Technical Support.

More info can be found in the S2810dn User’s Guide.

If these steps do not correct the problem, please contact Dell Technical Support.

Back to Top



記事ID: SLN298568

最終更新日: 08/03/2017 10:38 AM


この記事を評価する

正確
有益
分かりやすい
この記事は役に立ちましたか?
はい いいえ
フィードバックをお寄せください
コメントでは、以下の特殊文字は利用できません: <>()\
申し訳ありませんが、フィードバックのシステムは現在ご利用いただけません。後でもう一度試してください。

フィードバックをありがとうございます。