ナレッジベース

RAM Specifications for the Dell OptiPlex XM and XMT Computer Systems - KB Article - 156951




RAM Specifications and Memory Installation Guidelines for the Dell™ OptiPlex™ XM and XMT Desktop Systems

This document describes the RAM specifications and basic memory installation guidelines for the Dell OptiPlex XM and XMT systems.

Architecture

noninterleaved

Wait states

near zero

Single in line memory module (SIMM) sockets

four

SIMM capacities

4, 8, 16, 32, and 64 MB

SIMM type

32-bit, nonparity or parity

Minimum random access memory (RAM)

8 MB

Maximum RAM

256 MB

Memory access time

tRAC 70 nanoseconds (ns) and tCAC 20 ns

Memory module installation guidelines:

  • The four SIMM sockets can accommodate 8 to 256 MB of RAM.
  • Supported SIMM sizes are 4, 8, 16, 32, and 64 MB, rated at 70 ns or better.
  • SIMMs are 32-bit, nonparity or parity.
  • SIMMs must be installed in pairs of the same capacity.



 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

記事ID: SLN32142

最終更新日: 08/01/2010 12:00 AM


この記事を評価する

正確
有益
分かりやすい
この記事は役に立ちましたか?
はい いいえ
フィードバックをお寄せください
コメントでは、以下の特殊文字は利用できません: <>()\
申し訳ありませんが、フィードバックのシステムは現在ご利用いただけません。後でもう一度試してください。

フィードバックをありがとうございます。