Omitir para ir al contenido principal
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.

Número del artículo: 000178696


Precision Workstation M4600 RAID Configuration

Contenido del artículo


Síntomas

 
Article Summary: This article contains information regarding configuration of RAID on the Precision Workstation M4600.


Table of Contents:
  1. Requirements
  2. Configuring


1.   

 Requirements 

    

Raid 0 and 1 is supported through the addition of a 2nd storage hard drive via a Solid State Drive Mini Card (SSD MC). Alternatively, Users can choose to use the 128GB SSD MC as a single solid state storage as a stand-alone drive in addition to, or in replacement of the 2.5in drive without RAID. RAID requires two hard drive storage devices.
SLN288805_en_US__11389382872639.Note Image Note:
The SSD MC utilizes the same slot as a WWAN (Broadband) card, which means if you have a SSD mini card, you cannot have a WWAN card and vice versa.
The image below is a typical SSD Mini Card:

SLN288805_en_US__21390407153934.SSD mc

Back to Top


2.   

 Configuring 

    

Raid 0 or Raid 1 can be configured (with two drives present) in the Dell Precision M4600 by following these steps:
SLN288805_en_US__11389382872639.Note Image Note:
By default, Raid On is set to Enabled in the BIOS. If Raid On is disabled in the BIOS, Users will not be able to configure RAID.

To enable RAID in the BIOS:
  1. Enter System Setup
  2. Press the up- and down-arrow keys to highlight System Configuration. Press Enter
  3. Press the up- and down-arrow keys to highlight SATA Operation. Press Enter
  4. Press the left- and right-arrow keys to highlight RAID On. Press Enter
  5. Press the left- and right-arrow keys to highlight Save/Exit. Press Enter to exit System Setup and resume the boot process


To enter the RAID configuration utility:

  When prompted during system startup, press Ctrl and i <Cntrl i> at the same time to enter the configuration utility to create / manage Raid volume.
 
    Back to Top

    Click the button below to Tweet feedback or request assistance on anything in the above article.

    Propiedades del artículo


    Fecha de la última publicación

    21 feb 2021

    Versión

    4

    Tipo de artículo

    Solution