기술 문서

How to Manually Configure a Permanently Blacklisted MAC Address on Dell PowerConnect Wireless Switch Controller




This article explains how to manually configure a permanently blacklisted MAC address on Dell PowerConnect Wireless Switch Controller.



Objectives
  1. Overview
  2. Configuration Example
  3. Verification with Show Commands


Overview


A customer called in and explained that he needs to permanently blacklist a MAC address. He has followed the 6.4.x User Guide, and set the blacklist-time to "0" (indefinite), but the GUI and the CLI still show the blackout timer is counting down from 3600 seconds (default) for that MAC address.

From the 6.4.x User Guide, page 558 (Blacklisting Manually)

stm add-blacklist-client <macaddr>

From the 6.4.x User Guide, page 560 (Setting Blacklist Duration)

For clients that are blacklisted due to other reasons, including manual blacklisting. By default, this is set to
3600 seconds (one hour). You can set this to 0 to blacklist clients indefinitely.

wlan virtual-ap <profile>
blacklist-time <seconds>

Here is the link that provides the solution. http://community.arubanetworks.com/t5/Unified-Wired-Wireless-Access/Permanent-Blacklist-no-longer-working/td-p/132835


Configuration Example.


(Dell-Wireless) #show ap blacklist-clients

Blacklisted Clients
-------------------
STA reason block-time(sec) remaining time(sec)
--- ------ --------------- -------------------
a4:5e:60:d7:19:65 user-defined 2950 650

NOTE: The time remaining on the user defined black listed client.

(Dell-Wireless) #stm remove-blacklist-client a4:5e:60:d7:19:65

NOTE: Removes a blacklisted MAC address


(Dell-Wireless) #show ap blacklist-clients

Blacklisted Clients
-------------------
STA reason block-time(sec) remaining time(sec)
--- ------ --------------- -------------------

NOTE: Verifies the MAC address has been removed from the blacklist

(Dell-Wireless) # configure t
Enter Configuration commands, one per line. End with CNTL/Z

(Dell-Wireless) (config) #ap ap-blacklist-time 0
(Dell-Wireless) (config) #exit

NOTE: The command that is missing from the User's Guide, but explained in the link above


(Dell-Wireless) #stm add-blacklist-client a4:5e:60:d7:19:65

NOTE: Adds the blacklisted MAC address.



Verification with Show Command

(Dell-Wireless) #show ap blacklist-clients

Blacklisted Clients
-------------------
STA reason block-time(sec) remaining time(sec)
--- ------ --------------- -------------------
a4:5e:60:d7:19:65 user-defined 0 Permanent








문서 ID: HOW11120

최종 수정일: 06/09/2016 07:11 AM


이 문서 평가하기

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
지원 미지원
피드백을 보내 주십시오.
피드백 내용 중 유효하지 않은 문자가 있습니다. <> () &#92;는 허용되지 않는 특수 문자입니다.
죄송합니다. 현재 피드백 시스템은 사용하실 수 없습니다. 잠시 후에 다시 시도하십시오.

감사합니다. 피드백이 전송되었습니다.