기술 문서

How to assign services to a New Exchange Certificate in Exchange 2010 through Exchange Management Console



Article Summary: This article provides information about How to assigning services to a New Exchange Certificate in Exchange 2010 through Exchange Management Console


In the console tree, select Server Configuration.

In the action pane, click Assign Services to Certificate to open the Assign Services to Certificate wizard.

This wizard helps you assign the appropriate services to your certificate for your Exchange organization.

On the Assign Services page, use the check boxes in the Assign Services section to choose the services you want to assign to your certificate. If you chose services during certificate creation, these services will already be checked. Click Assign.

On the Completion page, verify that all of the services were assigned properly.

If you attempt to assign the Unified Messaging service to the certificate and the certificate is running in TCP mode only, assignment will fail. In order to use a certificate for Unified Messaging, it must be set to run in TLS mode or Dual mode.




Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

문서 ID: SLN286103

최종 수정일: 10/29/2014 10:41 AM


이 문서 평가하기

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
지원 미지원
피드백을 보내 주십시오.
피드백 내용 중 유효하지 않은 문자가 있습니다. <> () &#92;는 허용되지 않는 특수 문자입니다.
죄송합니다. 현재 피드백 시스템은 사용하실 수 없습니다. 잠시 후에 다시 시도하십시오.

감사합니다. 피드백이 전송되었습니다.