기술 문서

When adding a new remote authentication dial-in user service (RADIUS) server on a Dell PowerConnect 6024 or 6024F switch, the ACCT field sets to 0. - KB Article - 173561


When Adding New Remote Authentication Dial-In User Service (RADIUS) Server the ACCT Field Set to 0

In EWS, when adding a new RADIUS server, the Accounting Port (ACCT) field gets set to 0. If a new RADIUS server is created in the CLI, the Accounting Port (ACCT) field is set to one greater than the Authorization Port (Auth) field.

Steps to repeat:

  1. Create a RADIUS server from lcli.
  2. Create a RADIUS server from Web Based Interface (WBI).

The results are displayed below:

IP address Auth Acct TimeOut Retransmit DeadTime source IP Priority

--------------- ---- ---- ------- ---------- -------- --------------- --------

6.1.2.3 1812 1813 Global Global Global 0.0.0.0 0 <-------LCLI

10.10.1.10 1812 0 Global Global Global Global 0 <--------EWS

radius-server host 19.1.1.1 auth-port 1812 timeout 3 retransmit 3 deadtime

0 key "" source 0.0.0.0



Change the ACCT Port Number

Change the ACCT port number after creating the server from LCLI or EWS.

NOTE: Where accounting is not supported, ignore this information.



 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

문서 ID: SLN49107

최종 수정일: 11/14/2010 12:00 AM


이 문서 평가하기

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
지원 미지원
피드백을 보내 주십시오.
피드백 내용 중 유효하지 않은 문자가 있습니다. <> () &#92;는 허용되지 않는 특수 문자입니다.
죄송합니다. 현재 피드백 시스템은 사용하실 수 없습니다. 잠시 후에 다시 시도하십시오.

감사합니다. 피드백이 전송되었습니다.