기술 문서

How to Restore Factory Defaults on Dell Networking Force10 S4810


This article explains how to Restore Factory Defaults on Dell Networking Force10 S4810.

Important Points to Remember

  • When you restore all the units in a stack, these units are placed in standalone mode.
  • When you restore a single unit in a stack, only that unit is placed in standalone mode. No other units in the stack are affected.
  • When you restore the units in standalone mode, the units remain in standalone mode after the restoration.
  • After the restore is complete, the units power cycle immediately.

Command to Restore Factory Default

Restoring factory defaults will delete the existing persistent settings (configuration, stacking, fanout, etc.) After restoration the unit(s) will be power cycled immediately. Proceed with CAUTION !

Command

Parameters

FTOS# restore factory-defaults {0-5 | all} {bootvar | clear-all | nvram}

Restores and clears config, stacking, fanout, etc..
0-5 - indicates the switch number to be factory reset
all - indicates all switches to be factory reset
Bootvar - Reset Boot environment variables
Clear-all - Reset BootVar, NvRam and configurations
NvRam - Reset NvRam


Need more help?
Find additional PowerEdge and PowerVault articles

Visit and ask for support in our Communities

Create an online support Request






문서 ID: HOW10777

최종 수정일: 10/19/2017 05:58 AM


이 문서 평가하기

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
지원 미지원
피드백을 보내 주십시오.
의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.
죄송합니다. 현재 피드백 시스템은 사용하실 수 없습니다. 잠시 후에 다시 시도하십시오.

피드백을 보내주셔서 감사합니다.