기술 문서

How to Restore Factory Defaults on Dell Networking Force10 S6000


This article explains how to Restore Factory Defaults on Dell Networking Force10 S6000

Objectives
  1. Important Points to Remember
  2. Command to Restore Factory Default
  3. Examples

Important Points to Remember
  • When you restore all the units in a stack, these units are placed in standalone mode.
  • When you restore a single unit in a stack, only that unit is placed in standalone mode. No other units in the stack are affected.
  • When you restore the units in standalone mode, the units remain in standalone mode after the restoration.
  • After the restore is complete, the units power cycle immediately.


Command to Restore Factory Default

Warning - Restoring factory defaults will delete the existing persistent settings (configuration, stacking, fanout, etc.) After restoration the unit(s) will be power cycled immediately. Proceed with CAUTION!

Command Parameters
FTOS# restore factory-defaults stack-unit {0-5 | all} {bootvar | clear-all | nvram} Restores and clears config, stacking, fanout, etc..
Bootvar - Reset Boot environment variables
Clear-all - Reset BootVar, NvRam and configurations
NvRam - Reset NvRam



Examples
Example of resetting all stack units:

FTOS#restore factory-defaults stack-unit all nvram
**************************************************************
* Warning - Restoring factory defaults will delete the existing *
* startup-config and all persistent settings (stacking, fanout, etc.)*
* All the units in the stack will be split into standalone units. *
* After restoration the unit(s) will be powercycled immediately. *
* Proceed with caution !
***************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
0 Success Success
1 Success Success
2 Success Success
3 Not present
4 Not present
5 Not presentPower
Power-cycling the unit(s).
FTOS#


Example of resetting single switch

FTOS#restore factory-defaults stack-unit 1 nvram
*************************************************************
*Warning - Restoring factory defaults will delete the existing *
* persistent settings (stacking, fanout, etc.) *
* After restoration the unit(s) will be powercycled immediately. *
* Proceed with caution ! *
**************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
1 Success
Power-cycling the unit(s)
FTOS#





문서 ID: HOW10836

최종 수정일: 06/02/2016 10:21 AM


이 문서 평가하기

정확함
유용함
이해하기 쉬운
이 문서가 도움이 되셨나요?
지원 미지원
피드백을 보내 주십시오.
의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.
죄송합니다. 현재 피드백 시스템은 사용하실 수 없습니다. 잠시 후에 다시 시도하십시오.

피드백을 보내주셔서 감사합니다.