Knowledge Base

Print a Protocol Monitor report and Verify the country value is set correctly. [ Dell™ 3110cn, 3115cn Printer ]


  • Print a Protocol Monitor report and check the sending fax side protocol.
    1. When Ready to Print appears on the LCD, press the Down arrow button until Setup appears, and then press the Check mark button or the Menu button.
      Setup displays.
    2. Press the Down arrow button until Reports is displayed, and then press the Check mark button.
    3. Press the Left or Right arrow button until Protocol Monitor is indicated, and then press the Check mark button.
      The Protocol Monitor page prints.
    4. Check that the IP address reported in the Protocol Monitor report is in fact the IP address for the printer.

  • Verify the country value is set correctly.
    1. When the printer is ready (Copy, Scan, Fax appears in the LCD), press the Down button until Setup is indicated,
      then press the Select button.
    2. Press the Down button until Admin Menu appears, then press the Select button.
    3. Press the Down button until Fax Settings appears, then press the Select button.
    4. Press the Down button until Country appears, then press the Select button.
    5. Press the Left or Right arrow button to choose the country, then press the Select button twice to save the setting.
      The Please Wait... message will appear while the printer resets.

 


Article ID: SLN101455

Last Date Modified: 11/10/2010 12:00 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.