042-700 / 142-700: IOT over Heat Stop / IOT over Heat Forced Half Speed Error
042-700: Printing has been suspended because inside of the printer is extraordinarily hot. Wait until the error message turns off with the power to the printer remained on.
142-700: The printing speed has decreased because inside of the printer is extraordinarily hot. Do not start another printing job until the error message turns off.
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.
Article ID: SLN129681
Last Date Modified: 09/21/2014 08:25 PM
Rate this article
Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.
Thank you for your feedback.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
characters left.
Feature not supported by browser
FireFox does not support this feature with a secure connection(https). For the best experience, we recommend using Internet Explorer or Chrome.