Knowledge Base

ERROR: 010-351 IOT Fuser Life over or 010-421 replace fuser soon [Dell color laser printer 2150cn 2155cn]


IOT Fuser Life Over 010-xxx 010 EOL replace now soon 010-421 2150cn 2155cn 

010-351: IOT Fuser Life Over or 010-421 Replace Fuser Soon

Cause: The value of Fuser counter has reached or is approaching the replacement time.

Solution: Replace the Fuser with a new one.

NOTE: After replacing the fuser, the count must be reset on the printer. Follow these steps to do this.

1) Get into “Customer Mode” ("▲" key and"▼” while switching the machine on)

2) Press the "▼" key several times until "Parameter" is displayed. Press Select once

3) Press the "▼" key several times until "Life Fuser Sheet" is displayed. Press Select once

4) Press the "▼" key until "Initializing" is displayed. Press Select once

5) Press Select once, and Initializing the Life Counter of the Fuser is performed.

6) Machine should display “Initialized”.

7) Turn off the power to exit.

NOTE: This error code is not related to any hardware fault.

NOTE: When you have replaced the fuser, initialize the life counter of the Fuser.For details, refer to the supplied technical sheet.

 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: SLN143643

Last Date Modified: 07/24/2013 12:00 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.