Base de connaissances

Installing a 550 Sheet Feeder on Dell 1700 and 1700n Laser Printers


Article Summary: How to install a 550 sheet feeder on Dell 1700 and 1700n laser printers

Table of Contents:
  1. Fit the optional feeder to the printer
  2. Enable the feeder in the printer properties



1.

Fit the optional feeder to the printer


  1. Switch the printer off.
  2. Unpack the feeder and remove any packing material or tape.
  3. Place the feeder where the printer will be installed.
  4. Align the holes in the printer with the positioning posts on the optional feeder, then lower the printer into place.

    The printer is shown about to be lowered on to the optional feeder.

  5. Switch the printer on.

Back to Top


2.

Enable the feeder in the printer properties

  1. Open the printer properties dialogue.
  2. On the Install Options tab highlight "550-sheet drawer" then click Add and OK.

Back to Top


If you require further assistance or wish to give us feedback, please engage our technical team on Twitter.

 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

ID de l'article : SLN290499

Date de la dernière modification : 03/31/2014 12:00 AM


Noter cet article

Précis
Utile
Facile à comprendre
Avez-vous trouvé cet article utile ?
Oui Non
Envoyez-nous vos commentaires
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\
Désolé, notre système de collecte des commentaires est actuellement indisponible. Veuillez réessayer ultérieurement.

Merci pour vos commentaires.