Knowledge Base

How do I resolve a Divide Overflow error that may occur during the Power-On-Self-Test (POST) on my Dell Inspiron portable computer? - Technical Tip - 155345




Edit System Time And Date in the Power-On-Self-Test (POST)

To resolve the problem, perform the following steps:

  1. Reboot and during the POST, press the <F2> key to enter the System Setup.

  2. Change the system time and date to the correct time and date.

  3. Save the changes and exit the System Setup.
    The system should boot normally.

  4. Update the system to the latest FlashBIOS Update available from Dell Support.



 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: SLN18277

Last Date Modified: 08/02/2010 12:00 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.