This Article has info about Installing Windows 10 on a Precision Workstation Tx600 System Equipped with a single hard drive attached to a PERC H310 RAID Controller.
When Windows 10 is installed on a single hard drive in a Precision Workstation Tx600 system equipped with a PERC H310 RAID Controller, Windows 10 will not see the hard drive.
You can resolve the by configuring the drive to a single drive RAID 0 array.
This is accomplished by first converting it the physical drive to a RAID disk and then configuring the virtual disk to a RAID 0 array of 1 drive.
Enter the RAID setup by pressing the CTRL + R Hotkey combination at boot.
You can do this by following the steps indicated below: (See Figures 1 & 2.)
Figure 1. - No Hard Drive configured in the RAID Array
Figure 2. - Selecting the Physical Disk in the RAID Setup.
Figure 3. - Identifying the drives for the RAID Array.
Figure 4. - Selecting the drives for the RAID Array.
Figure 5. - Completing the RAID Array configuration.
Identificación del artículo: SLN299153
Última fecha de modificación: 09/19/2017 09:02 AM