Knowledge Base

Cleaning the Feed Roller on a Dell 2150cn/cdn Laser Printer


Article Summary: This article provides Information on Cleaning the Feed Roller on a Dell 2150cn/cdn Laser Printer


Table of Contents:
  1. Cleaning the Feed Roller on a Dell 2150cn/cdn Laser Printer



1.

Cleaning the Feed Roller on a Dell 2150cn/cdn Laser Printer


During regular usage of your printer it is likely that the feed rollers will become dirty and can in some cases become worn or cracked after extensive use.

It is recommended, as part of regular maintenance, that you clean the feed rollers in order to ensure that paper is pulled freely and Paper Jams avoided.

This article provides detailed information on cleaning the internal feed roller in the 2150cn/dcn Laser printer.
  1. Ensure that the printer is turned off
  2. Pull the standard 250-sheet tray out of the printer about 200mm
  3. Hold the standard 250-sheet tray with both hands, and remove it from the printer
  4. Push the side button to open the front cover
  5. Open the belt unit




  6. Turn the four PHD lock levers 90-degrees counter-clockwise




  7. Hold the gray tabs, and then pull out the PHD unit
  8. Clean the feed roller inside the printer thoroughly with a lint free dry cloth




  9. If the feed roller looks damaged, worn or cracked, please contact Dell Technical Support via the Twitter button below, to advise of issue
  10. After cleaning the roller, Insert the PHD unit until it stops, and then turn the four PHD lock levers 90- degrees clockwise to lock the PHD unit
  11. Close the belt unit, and push at the top of the unit until it clicks
  12. Close the front cover
  13. Insert the standard 250-sheet tray into the printer, and push until it stops

Back to Top


If you require further assistance or wish to give us feedback, please engage our technical team on Twitter.

 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: SLN286168

Last Date Modified: 11/12/2013 12:00 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Feedback shows invalid character, not accepted special characters are <> () &#92;
Sorry, our feedback system is currently down. Please try again later.

Thank you. Your feedback has been sent.