Knowledge Base

Latitude XT3: Removal guide for the Bottom Cover, Keyboard and Keyboard Frame




Table of Contents:

  1. Bottom cover
  2. Keyboard frame
  3. Keyboard


This article provides information on removing components from the Latitude XT3



1. Bottom cover


1. Pre-Removal Instructions Before removing the Bottom cover:

  • During installation or removal of any hardware always ensure all data is backed up properly
  • Disconnect any telephone, network, or USB cables from the computer
  • Disconnect the computer and all attached devices from their electrical outlets
  • Remove the Battery, Bottom Door and Hard Drive

2. Establishing image.




3. Remove the two bottom cover screws.




4. Disengage the bottom cover from the edge of the system and remove the bottom cover from the system.




5. Complete.




Back to Top



2. Keyboard frame


1. Pre-Removal Instructions Before removing the Keyboard frame:

  • During installation or removal of any hardware always ensure all data is backed up properly
  • Disconnect any telephone, network, or USB cables from the computer
  • Disconnect the computer and all attached devices from their electrical outlets
  • Remove the Battery

2. Establishing image.




3. By hand, disengage the keyboard frame from the system and remove it from the system.




4. Complete.




Back to Top



3. Keyboard


1. Pre-Removal Instructions Before removing the Keyboard:

  • During installation or removal of any hardware always ensure all data is backed up properly
  • Disconnect any telephone, network, or USB cables from the computer
  • Disconnect the computer and all attached devices from their electrical outlets
  • Remove the Battery, Bottom Door and Keyboard frame

2. Establishing image.




3. Remove the two screws at the bottom of the system.




4. Remove the four keyboard screws.




5. Flip the keyboard over.




6. Disconnect the keyboard data cable from the system board.




7. Remove the keyboard from the system.




8. Remove the black Mylar tape securing the keyboard data cable to the back of the keyboard.




9. Separate the keyboard date cable and the keyboard.




10. Complete.





Back to Top

Return to the Latitude XT3 Teardown/Removal Index.



If you require further assistance or wish to give us feedback, please engage our technical team on Twitter.





Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Artikel-id: SLN291265

Laatste wijzigingsdatum: 09/10/2014 10:14 AM


Beoordeel dit artikel

Nauwkeurig
Nuttig
Eenvoudig te begrijpen
Was dit artikel nuttig?
Ja Nee
Stuur ons feedback
Opmerkingen mogen geen speciale tekens bevatten: <>() \
Excuses, ons feedbacksysteem is momenteel offline. Probeert u het later nog eens.

Hartelijk dank voor uw feedback.