Kunnskapsbase

Network - Brocade 4424 or 5424 Fibre switch may experience unexplained reboot


Issue:

Brocade 4424 or 5424 Fibre switch may experience unexplained reboot.

Reboot event will look similar to this, with no events leading to the reboot:

[HAM-1004], 862751, CHASSIS, INFO, M5424, Processor rebooted - Reset.

Solution:

Verify there is nothing attached to the serial port. Remove any cables connected to the serial port.

Additional Information:

When a Brocade 5424 switch shows it rebooted, without clear explanation or core file created, verify that there is nothing attached to the serial port. In this switch, there is not a physical Ethernet port for management. The port on the switch is actually for a serial cable connection. This port has caused some confusion and network cables have been attached, which can cause unnecessary interrupts.

If you run into this scenario, confirm that there is not an Ethernet cable attached to the serial port. If so, remove this.

Another way to check this is that in the supportshow log file the interrupts for serial port will have a fairly high value. Perform a search in the log for /proc/interrupts: Gather new after a few hours and compare if this value is increasing rapidly.

/proc/interrupts :

CPU0

1: 370855 UIC0 Level serial

 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Artikkel-ID: SLN156546

Dato sist endret: 08/20/2013 12:00 AM


Vurder denne artikkelen

Nøyaktig
Nyttig
Brukervennlig
Var denne artikkelen nyttig?
Ja Nei
Send oss tilbakemelding
Tilbakemelding viser ugyldig tegn, ikke godkjente spesialtegn er <> () &#92;
Beklager, men tilbakemeldingssystemet vårt er nede for øyeblikket. Prøv igjen senere.

Takk. Meldingen er sendt.