Baza wiedzy

H700 - I2C cannot find idle bus


Issue:

Battery shown in state failed by monitoring software. OpenManage Server Administrator CLI shows battery state = failed / battery status = critical. RAID controller log of PERC H700 shows several of the following lines:

Solution:

I2C messages in the controller log refer to internal communication (to iDRAC for example) on the SMbus. These messages can be ignored.

Additional Information:

I2C 1 reset

I2C 1 cannot find idle bus!

I2C b PID 1 TIMEOUT!

I2C 1 reset

H700 RAID Controller Log

I2C messages in the controller log refer to internal communication (to iDRAC for example) on the SMbus. These messages can be ignored.

 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Identyfikator artykułu: SLN164039

Data ostatniej modyfikacji: 07/19/2013 12:00 AM


Oceń ten artykuł

Trafne
Przydatne
Łatwe do zrozumienia
Czy ten artykuł był przydatny?
Tak Nie
Wyślij nam swoją opinię
Komentarze nie mogą zawierać znaków specjalnych: <>()\
Niestety, nasz system przekazywania opinii jest obecnie niedostępny. Spróbuj ponownie później.

Dziękujemy za uwagi.