Knowledge Base

Why does the Simplified Array Manager tool display a "Controller is busy" error message on my Dell PowerVault 77XN? - KB Article - 168449


Wait for the controller to finish its current task.

When the controller is performing certain functions, for example resynching, rebuilding or reconstructing, the user is prevented from performing new tasks. Wait for the controller to finish its current task and try the operation again.

NOTE: For more information regarding using the Simplified Array Manager tool on your NAS appliance, refer to the online User's Guide located at Support Dell.




 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: SLN69133

Last Date Modified: 11/13/2010 12:00 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.