База знаний

Duplicate IP Address Logged by Remote Systems When Teaming Broadcom NICs


This article provides information on what to do if a duplicate IP address is logged by remote systems when teaming Broadcom Network Interface Cards (NIC)s.



Table of Contents
  1. Description of the Issue
  2. Solution

1. Issue


When Broadcom Network Interface Card (NIC)s are Smart Load Balance (SLB) teamed with Livelink enabled and the Broadcom driver release is prior to version T4.1.
The other systems on the network may report duplicate Internet Protocol (IP) addresses. It happens due to the Broadcom teamed NICs sending Address Resolution Protocol (ARP)s with an invalid origination IP address.

This issue is not present if Livelink is disabled or SLB teaming is not utilized.


2. Solution

You do not need to replace any hardware or reinstall software. Upgrading to Broadcom release T4.1 or later will resolve this issue. Please see our Drivers and Downloads site for the latest version.





Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Код статьи: SLN125054

Дата последнего изменения: 02/24/2016 05:32 AM


Оцените эту статью

Точно
Функционально
Просто понять
Помогла ли вам эта статья?
Да Нет
Отправьте нам свое мнение
Комментарии не должны содержать следующие специальные символы: <>()\
К сожалению, наша система обратной связи в настоящее время не работает. Повторите попытку позже.

Благодарим вас за отзыв.