Kunskapsbank

Brocade 825 Fibre Card not being seen in Windows 2012 R2


Brocade 825 Fibre Card not being seen in Windows 2012 R2



Check the following to resolve the issue:

  • SFP+ modules and Brocade Card compatibility
  • Check status LEDs on the card
  • Check cables are functioning. i.e. swap cables with know good.
  • Check slot priority on the motherboard
  • Ensure correct speed setting in BIOS of the card. If in doubt, set to Auto.
  • Update Windows 2012 R2 driver from Qlogic web site.

Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Artikel-ID: SLN292436

Senast ändrad: 11/26/2015 08:52 AM


Betygsätt den här artikeln

Korrekt
Användbart
Lätt att förstå
Var den här artikeln till nytta?
Ja Nej
Skicka dina synpunkter
Kommentarer får inte innehålla följande specialtecken: <>()\
Vårt feedbacksystem är tyvärr ut funktion just nu. Försök igen senare.

Tack för dina synpunkter.