Kunskapsbank

The Run Command is not Available By Default in Microsoft Windows Vista. - KB Article - 303400




Discussion - Vista Start Button

When you click the Start button in Windows Vista you may notice that there is no Run option. The Run option is disabled by default in Windows Vista.



Tell Me How/Let Me Practice - Enable the Run Command in Windows Vista.

Click Show Me How to walk through the steps below.



Enable the Run command in Windows Vista.

To enable the Run command in Windows Vista, perform the following steps:

  1. Right-click the Start button and left-click Properties.
    The Taskbar and Start Menu Properties window appears.
  2. Click the Start Menu tab.
  3. Click Customize.
    The Customize Start Menu window appears.
  4. Check the Run Command checkbox.
  5. Click OK and OK again to exit Taskbar and Start Menu Properties.



 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Artikel-ID: SLN37326

Senast ändrad: 08/17/2010 12:00 AM


Betygsätt den här artikeln

Korrekt
Användbart
Lätt att förstå
Var den här artikeln till nytta?
Ja Nej
Skicka dina synpunkter
Synpunkterna innehåller felaktiga tecken, du får inte använda specialtecknen <> () &#92;
Vårt feedbacksystem är tyvärr ut funktion just nu. Försök igen senare.

Tack. Dina synpunkter har skickats.