Databáza poznatkov

How to Manually Configure a Permanently Blacklisted MAC Address on Dell PowerConnect Wireless Switch Controller




This article explains how to manually configure a permanently blacklisted MAC address on Dell PowerConnect Wireless Switch Controller.



Objectives
  1. Overview
  2. Configuration Example
  3. Verification with Show Commands


Overview


A customer called in and explained that he needs to permanently blacklist a MAC address. He has followed the 6.4.x User Guide, and set the blacklist-time to "0" (indefinite), but the GUI and the CLI still show the blackout timer is counting down from 3600 seconds (default) for that MAC address.

From the 6.4.x User Guide, page 558 (Blacklisting Manually)

stm add-blacklist-client <macaddr>

From the 6.4.x User Guide, page 560 (Setting Blacklist Duration)

For clients that are blacklisted due to other reasons, including manual blacklisting. By default, this is set to
3600 seconds (one hour). You can set this to 0 to blacklist clients indefinitely.

wlan virtual-ap <profile>
blacklist-time <seconds>

Here is the link that provides the solution. http://community.arubanetworks.com/t5/Unified-Wired-Wireless-Access/Permanent-Blacklist-no-longer-working/td-p/132835


Configuration Example.


(Dell-Wireless) #show ap blacklist-clients

Blacklisted Clients
-------------------
STA reason block-time(sec) remaining time(sec)
--- ------ --------------- -------------------
a4:5e:60:d7:19:65 user-defined 2950 650

NOTE: The time remaining on the user defined black listed client.

(Dell-Wireless) #stm remove-blacklist-client a4:5e:60:d7:19:65

NOTE: Removes a blacklisted MAC address


(Dell-Wireless) #show ap blacklist-clients

Blacklisted Clients
-------------------
STA reason block-time(sec) remaining time(sec)
--- ------ --------------- -------------------

NOTE: Verifies the MAC address has been removed from the blacklist

(Dell-Wireless) # configure t
Enter Configuration commands, one per line. End with CNTL/Z

(Dell-Wireless) (config) #ap ap-blacklist-time 0
(Dell-Wireless) (config) #exit

NOTE: The command that is missing from the User's Guide, but explained in the link above


(Dell-Wireless) #stm add-blacklist-client a4:5e:60:d7:19:65

NOTE: Adds the blacklisted MAC address.



Verification with Show Command

(Dell-Wireless) #show ap blacklist-clients

Blacklisted Clients
-------------------
STA reason block-time(sec) remaining time(sec)
--- ------ --------------- -------------------
a4:5e:60:d7:19:65 user-defined 0 Permanent








Identifikátor článku: HOW11120

Dátum poslednej zmeny: 06/09/2016 07:11 AM


Ohodnotiť tento článok

Presné
Užitočné
Jednoducho pochopiteľné
Bol pre vás tento článok užitočný?
Áno Nie
Pošlite nám pripomienky.
Pripomienky obsahujú neplatný znak. Nie je možné používať špeciálne znaky <> () &#92;.
Ľutujeme, náš systém odosielania pripomienok je momentálne nefunkčný. Skúste znova neskôr.

Ďakujeme. Vaše pripomienky boli odoslané.