Databáza poznatkov

MegaCLI Commands to Pull Controller Logs from the LSI 9265-8i and the LSI 9260-8i RAID Controllers

Article Summary: This article provides information on MegaCLI commands to pull controller logs from the LSI 9265-8i and the LSI 9260-8i.


What are the MegaCLI™ commands to pull controller logs from the LSI 9265-8i™ and the LSI 9260-8i™?


The Dell™ DSET Utility does not support PowerEdge™ C-Series servers. Install the MegaCLI from Below are the most common commands.

Megacli adpeventlog getevents aall > getevents.txt

megacli fwtermlog dsply aall > fwtermlogdsply.txt

MegaCli -LdPdInfo -aALL > c:\logs\ldpdinfo.txt

MegaCli -CfgDsply -aALL > c:\logs\cfgdsply.txt

MegaCli -PdList -a0 > c:\logs\pdlist.txt

MegaCli -AdpAllInfo -aALL > c:\logs\adpallinfo.txt

Megacli -encinfo -aall > encinfo.txt

Support Tools for LSI 9260-8i for Cloudedge Servers

Dell PowerEdge C Server System Management


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Identifikátor článku: SLN289672

Dátum poslednej zmeny: 01/14/2014 12:00 AM

Ohodnotiť tento článok

Jednoducho pochopiteľné
Bol pre vás tento článok užitočný?
Áno Nie
Pošlite nám pripomienky.
Poznámky nemôžu obsahovať nasledujúce špeciálne znaky: <>()\
Ľutujeme, náš systém odosielania pripomienok je momentálne nefunkčný. Skúste znova neskôr.

Ďakujeme vám za pripomienky.