Databáza poznatkov

How to Replace the Transfer Belt on the 3130cn / 3130cdn Dell Laser Printer


Table of Contents:

  1. How to Replace the Transfer Belt on the 3130cn / 3130cdn Dell Laser Printer

This article provides information on "How to Replace the Transfer Belt on the 3130cn / 3130cdn Dell Laser Printer"


1. How to Replace the Transfer Belt on the 3130cn / 3130cdn Dell Laser Printer

  1. Switch the power off. Open the front the cover.

  2. Pull up on the belt release levers, then rotate the belt up.

  3. With the belt unit at 90° to the front cover, lift the belt on the right side until the peg is clear of the slot. Lift the belt up and to the right to remove.

  4. Unpack a new belt unit. With the belt unit at 90° to the front cover insert the left peg into the mounting hole. Lower the right side peg into the slot.

  5. Lower the belt until it clicks into place.

  6. Remove the protective film cover from the new belt.

  7. Close the front cover.

More info can be found in the 3130cn User’s Guide.

If these steps do not correct the problem, please contact Dell Technical Support.

Back to Top



Identifikátor článku: SLN286412

Dátum poslednej zmeny: 08/03/2015 02:05 PM


Ohodnotiť tento článok

Presné
Užitočné
Jednoducho pochopiteľné
Bol pre vás tento článok užitočný?
Áno Nie
Pošlite nám pripomienky.
Poznámky nemôžu obsahovať nasledujúce špeciálne znaky: <>()\
Ľutujeme, náš systém odosielania pripomienok je momentálne nefunkčný. Skúste znova neskôr.

Ďakujeme vám za pripomienky.