Databáza poznatkov

Use OpenManage Switch Administrator to change the Privileged Exec (enable) password on the 3500, 5500, 6200, 7000, 8000, 8100, N2000, N3000, N4000 series switches


Article Summary: This article provides the necessary steps to add or change the Privileged Exec password from the web interface.

Discussion: Some firmware releases may not have required an enable password to be set when using telnet or SSH for switch management. If firmware is upgraded such that an enable password is required, it can be set via console or via the web interface. This article outlines the procedure for setting the enable password via the web interface.





1. Open the Dell OpenManage Switch Administrator web interface by entering the IP address of the switch in your web browser. Expanding the directories can be done by clicking on the title of each directory, clicking on the + symbol to each category’s title, or clicking directly on each of the options within the main window.

2. Navigate through: System > Management Security > Enable Password

3. Enter a new Enable password and click Apply.

Note: The 3500 and 5500 series switches may require entering an Enable Access Level. The default value of 1 only gives read access. Select 15 to give read/write access.

4. Save the configuration: Click on the diskette icon at the top of the window and acknowledge the warning.

Note: A 6200 series switch does not have a save icon. Navigate through: System > File Management > Copy Files. Select Copy Configuration, verify Source: Running Config and Destination: Startup Config, then select Apply Changes.


Identifikátor článku: HOW10468

Dátum poslednej zmeny: 06/09/2016 07:56 AM


Ohodnotiť tento článok

Presné
Užitočné
Jednoducho pochopiteľné
Bol pre vás tento článok užitočný?
Áno Nie
Pošlite nám pripomienky.
Poznámky nemôžu obsahovať nasledujúce špeciálne znaky: <>()\
Ľutujeme, náš systém odosielania pripomienok je momentálne nefunkčný. Skúste znova neskôr.

Ďakujeme vám za pripomienky.