Replace the Lamp On the Dell 4100 Projector
Lamp is approaching the end of its useful life in full power operation. Replacement suggested!
|CAUTION:||Do not touch the bulb or the lamp glass at any time. The bulb may explode due to improper handling, including the touching of the bulb or the lamp glass.|
To replace the lamp, perform the following steps:
For information on purchasing replacement parts for your Dell branded projector, navigate to the following Dell website:
Turn off the projector and disconnect the power cord.
Let the projector cool for at least 30 minutes.
Loosen the 2 screws that secure the lamp cover, and remove the cover.
Loosen the 3 screws that secure the lamp.
Pull up the lamp by its metal handle.
Reverse steps 1 through 5 to install the new lamp.
Press the Power button.
Using the remote control, press the Menu button.
Using the Four Directional button in the center of the remote, highlight the Management option.
Using the Four Directional button, press the right side of the button to enter the selection.
Using the Four Directional button, highlight the Lamp Reset option.
Using the Four Directional button, press the right side of the button to highlight the Yes option.
The projector begins to reset the lamp.
The lamp contains mercury. Disposal of this material may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance.
Identificación del artículo: SLN32200
Última fecha de modificación: 03/16/2018 02:15 PM