Consulta de temas

USC May Not List NIC Daughtercards in a Blade Server's Mezzanine PCI Slot


Article Summary: USC May Not List NIC Daughtercards in a Blade Server's Mezzanine PCI Slot

Article Summary: This article describes that ethernet NIC daughtercards in blade servers may be listed as installed in a PCI Slot X when configured with USC.

Confusion When Installing More Than One Daughtercard

Ethernet NIC daughtercards in blade servers may be listed as installed in a PCI Slot X when configuring with Unified Server Configuration (USC). Instead, the location should be listed as a mezzanine slot letter. This may be confusing when installing more than one daughtercard of the same type.


System Is Functioning Normally

The system is functioning normally. Mezzanine PCI slots are labeled A and B on half-height blade servers and A - D on full-height blade servers. USC may instead list the location as Slot 1 which corresponds to MEZZ A.






Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Identificación del artículo: SLN85655

Última fecha de modificación: 02/23/2016 03:00 PM


Califique este artículo

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
No
Envíenos sus comentarios
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"
Disculpe, nuestro sistema de comentarios está actualmente inactivo. Vuelva a intentarlo más tarde.

Muchas gracias por sus comentarios.