Knowledge Base

Replacing the Transfer Roller on the Dell Laser Printer 5100CN or 5110CN


Table of Contents:

  1. Replacing the Transfer Roller on the Dell Laser Printer 5100CN or 5110CN

This article provides Information on Replacing the Transfer Roller on the Dell Laser Printer 5100CN or 5110CN.


Replacing the Transfer Roller on the Dell Laser Printer 5100CN or 5110CN


Press the front latch button, and then rotate open the inner duplex assembly.



Press the right and left end retaining tabs inward.



Rotate the transfer roller upward, and then lift it out of the chassis.







Reverse the previous steps to replace the transfer roller.

Back to Top




If you require further assistance or wish to give us feedback, please engage our technical team on Twitter.




Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: SLN143096

Last Date Modified: 01/16/2015 03:00 PM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Feedback shows invalid character, not accepted special characters are <> () &#92;
Sorry, our feedback system is currently down. Please try again later.

Thank you. Your feedback has been sent.