Knowledge Base

ERROR: 006-370 IOt ROS failure [Dell color laser printer 2150cn]


Rosemary 

006-370 : IOT ROS Failure

Cause: The operation error of ROS (Internal Printhead) is detected.

Solution: Turn the power off, wait 10 seconds and then re-start the printer. If the error recurs, please contact Dell Technical Support.

 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: SLN234589

Last Date Modified: 07/24/2013 12:00 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.