知識庫

Why is a hard drive not detected when switching from the onboard Intel Controller to a PERC H310 SAS controller?



Article Summary: Why is a hard drive not detected when switching from the onboard Intel Controller to a PERC H310 SAS controller?


Hard drive not detected

Changing the drive configuration in a Precision Workstation T3600, T5600 or T7600 from the Intel onboard SAS controller to a PREC H310, the hard drive fails to detect.


Ensure that the Data cable connection on the H310 is properly seated in the card connector.

The most often duplicated failure seen when the SAS controller is changed from the Intel Onboard SAS controller to a PERC H310 is improper connection of the data cable to the controller card.

Unlike most connections, the SAS data cable can be plugged into the data port on the H310 BACKWARDS. When installing the H310, ensure that the cable clip on the cable points to the bottom in a tower or to the left as viewed from the front of the chassis.

When correctly inserted there is an audible CLICK and the cable cannot be removed when pulled and the retention clip is not depressed.

If incorrectly inserted, the cable will easily pull from the connection without depressing the clip (The clip when cable is correctly installed faces away from the back side of the card.)


REFERENCE: H310 users guide





文章 ID: SLN172017

上次修改日期: 08/23/2017 08:35 AM


為本文評分

準確
實用
易懂
這篇文章對您有用嗎?
傳送意見反應
評語中不得包含下列特殊字元:<>()\
很抱歉,我們的意見回饋系統目前關閉中。請稍後再試。

感謝您的寶貴意見。