База знаний

Drive Not Visible As Hotspare in BIOS on CERC SATA 1.5/2s - Product Support Quick Note (PSQN) - 275260

A hard drive may not appear in the CERC SATA 1.5/2s Controller BIOS.

On a system with a CERC SATA 1.5/2s controller, a newly added or replacement drive may not appear in the Add hotspare option of the controller BIOS (CTRL-A). The new drive may be a legacy drive, and must first be configured before it is used as a spare.


CERC 1.5/2s is a software-based RAID solution, NOT hardware based. Depending on the platform, two different ROM versions are used:

  • Option ROM version 2024 is used on the following systems:
    • PowerEdge 1420SC
    • PowerEdge 420SC
    • PowerEdge 1800
  • Option ROM version 2026 is used on the following systems:

    • PowerEdge 1420SC
    • PowerEdge 420SC

Configure the drive in the CERC SATA 1.5/2s BIOS.

To configure the drive in the CERC SATA 1.5/2s BIOS, perform the following steps:

  1. Reboot the system, and press the <Ctrl> + <A> keys at the same time when prompted during POST.
    The BIOS RAID Configuration Utility menu appears.
  2. Press the <up arrow> or <down arrow> key until Array Configuration Utility is highlighted, and press the <Enter> key.
    The Main Menu appears.
  3. Press the <down arrow> key until Configure Drives is highlighted, and press the <Enter> key.
    A list of available drives appears on the left side of the screen..
  4. Press the the <down arrow> key until the new drive is highlighted, and press the <Insert> key.
    The new drive appears in the list of selected drives on the right side of the screen.
  5. Press the <Enter> key.
    A warning message appears.
  6. After reading the warning message, type Y after the question Do you want to continue? <Yes/No>:
    The new drive will be configured for use.

Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Код статьи: SLN43172

Дата последнего изменения: 08/12/2010 12:00 AM

Оцените эту статью

Просто понять
Помогла ли вам эта статья?
Да Нет
Отправьте нам свое мнение
Комментарии не должны содержать следующие специальные символы: <>()\
К сожалению, наша система обратной связи в настоящее время не работает. Повторите попытку позже.

Благодарим вас за отзыв.