База знаний

Why does the Iomega One-Step Backup attempt to connect to my Kodak DC210 camera? - Technical Tip - 167066




This is functioning as designed because, the Kodak software sets the DC210 as a "virtual" drive and the Iomega One-Step Backup scans all drives to see what files are on them.

Your system is functioning as intended, and this is not a problem. If your camera is attached and in the connect mode, the One-Step Backup will read the files (pictures) on the camera and then allow you to continue with your backup.



You have the Kodak DC210 software installed.

This happens when you choose to customize your backup and go to the "File Selection" tab and you have the Kodak DC210 software installed. The Kodak software sets the DC210 as a "virtual" disk drive and the "File Selection" portion of the Iomega One-Step Backup scans all drives to see what files are on them. This scan causes the system to attempt communication to the camera, and once it detects that the camera is not attached, it will allow you to continue with your backup. If your camera is attached and in the connect mode, the One-Step Backup will read the files (pictures) on the camera and then allow you to continue with your backup.



 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Код статьи: SLN43503

Дата последнего изменения: 08/14/2010 12:00 AM


Оцените эту статью

Точно
Функционально
Просто понять
Помогла ли вам эта статья?
Да Нет
Отправьте нам свое мнение
Комментарии не должны содержать следующие специальные символы: <>()\
К сожалению, наша система обратной связи в настоящее время не работает. Повторите попытку позже.

Благодарим вас за отзыв.