Knowledge Base

How do I restore setup defaults on my Dell EC Series Desktop system? - KB Article - 318268




Restore Factory Defaults

  1. Restart the computer.

  2. At the first text on the screen, or the Dell logo, press <Delete> every three seconds.

  3. When the System Setup screen appears, press <F9> to load the factory defaults.

  4. The Load Optimal Defaults message appears. OK is highlighted by default.

  5. Press <Enter> to load defaults.

  6. Press the <Right> arrow key until Exit is highlighted.

  7. Press <Enter> on Save Changes and Exit.

  8. The Save configuration changes and exit setup? message appears. OK is highlighted by default.

  9. Press <Enter> to load defaults. The system restarts.



 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: SLN67164

Last Date Modified: 07/30/2010 12:00 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.