Knowledge Base

Installing Dell™ OpenManage™ Array Manager for Microsoft® Windows NT® 4.0 or Windows® 2000 - Technical Tip - 149305

Download the Most Current Dell OpenManage Array Manager (DOMA) Version

  1. Browse to Dell Support.

  2. Click the link for Downloads.

  3. Search for the latest version of the Dell OpenManage Array Manager under Systems Management for your system. For more information about searching for and downloading files from Dell, click the Help link on the Downloads page.

  4. If prompted with an Export Compliance Disclaimer, read the disclaimer, and then click Yes, I Accept this Agreement.

  5. When the File Download window appears, click to select Save this program to disk and then click OK.

  6. Select a location that is convenient to download the file to and click OK.

  7. Using an unzipping utility, unzip the contents of the downloaded file to C:\DOMA3.

Dell OpenManage Array Manager 3.0 Installation

  1. Click the Start button, click Run, and then type in the Open box c:\doma3\setup\setup. Click OK.

  2. Click Next to continue.

  3. Read the License Agreement and click Yes to continue.

  4. Select the type of install that you would like, and then click Next to continue.

    If you have Windows 2000, a Warning window appears and explains that Array Manager will replace the default Disk Management utility installed by Windows 2000 (Figure 1).

    Figure 1: Warning

    Click OK if you receive this warning window. An
    Information window appears and provides information on the Dell PowerEdge RAID Controller (PERC) firmware.

  5. Click OK to continue. The System Requirements window appears (Figure 2).

    Figure 2: System Requirements

  6. This window allows you to verify that the system meets the installation requirements. Click Next to continue.

  7. If you would like to change the default installation location, click Browse and select a different location. Otherwise, click Next to continue. The Setup Status window appears as files copy to the hard drive.

    If SNMP is not installed, you will receive a warning. Click OK to continue. SNMP is not an installation requirement; it is used for SNMP traps. For further information on SNMP and DOMA, refer to the Array Manager Help file.

  8. Click Finish to restart the computer. If your system is running Windows 2000, upon reboot the Dell OpenManage Array Manager window appears.

  9. Click OK to continue. The installation is complete.


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: SLN49241

Last Date Modified: 11/14/2010 12:00 AM

Rate this article

Easy to understand
Did this article solve your problem?
Yes No
Send us feedback
Change the CAPTCHA codeSpeak the CAPTCHA code
Enter Captcha Code
There is an error with an entry. Please try again entering your CAPTCHA code.
Feedback shows invalid character, not accepted special characters are <> () &#92;
Sorry, our feedback system is currently down. Please try again later.

Thank you. Your feedback has been sent.