Knowledge Base

How to Install or Reseat SO-DIMM (Mobile Computer) Memory - KB Article - 347972




Article Summary: How to Install or Reseat SO-DIMM (Memory Computer) Memory

Article Summary:Steps to install or reseat the SO-DIMM (memory computer) memory are discussed in the article.



Steps to Install or Reseat the SO-DIMM

Caution:
Before performing any of the procedures in this section, read and follow the safety instructions in Dell Knowledge Base Article: "Precautionary Measures for Personal Safety" Article ID: 339031.

Caution:

The following process should be done under the supervision of an Alienware Technical Support Representative. Any hardware modifications done to the system without the supervision of Alienware may void your system's warranty.

Note:

The location of the memory slots may be different, it depends on the system is used. Kindly refer to the system's manual to determine their location. If the system manual is not available, it may be obtained online from our Support Area. Click to Contact Dell to access the Support Area.

Perform the steps below to install or reseat the SO-DIMM memory.

  1. Always turn-off the computer and remove the rechargeable battery pack before installing memory.

  2. Insert the module into the socket at a slight angle (approximately 30 degrees). Ensure that the socket and module are both keyed, which means the module can be installed in only one orientation.

  3. To seat the module into the socket, apply firm, even pressure to each end of the module (see the arrows) until you feel it slip down into the socket. If there are problems for getting the module to seat properly, try rocking the module up and down slightly while continuing to apply pressure. When properly seated, the contact fingers on the edge of the module will almost completely disappear inside the socket.

  4. With the module properly seated in the socket, rotate the module downward (Figure 1). Continue pressing downward until the clips at each end of the socket lock into position. With most sockets, a distinctive click sound will be heard, indicating the module is correctly locked.


Figure 1: Instructions to reseat the memory (Click the image to enlarge)

Keyed
Clips

Click Contact Dell to obtain contact information for technical support.

Click Warranty Information for more about the system's warranty.



 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: SLN73849

Last Date Modified: 04/05/2016 03:26 PM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.