Knowledge Base

5330dn Fuser Reset




Table of Contents:

  1. Reset The Fuser Counter

This article provides information on resetting the fuser life count after replacing the fuser on the 5330dn Dell Laser Printer


1. Reset The Fuser Counter

After replacing the fuser for a fuser end of life error, you may still receive the end of life error. The fuster counter needs to be reset before the message will clear.

To reset the fuser counter, perform the following steps:

  1. From the main menu, press the following sequence to access the Tech Menu
  2. Press Menu, Up, Left, Checkmark, Right, Cancel (must be performed quickly, within 3 seconds)
  3. Press Menu, select Tech Menu, then select Data Setup, and then select Clear Fuser Cnt

Back to Top


Article ID: QNA33299

Last Date Modified: 09/21/2017 04:18 PM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Feedback shows invalid character, not accepted special characters are <> () &#92;
Sorry, our feedback system is currently down. Please try again later.

Thank you. Your feedback has been sent.