Consulta de temas

OptiPlex 9010 All in One (AIO) Removal Guide for the Vesa Cover, System Stand, Rear Cover, Memory and Optical Drive



This article provides information on removing components from a OptiPlex 9010 All-In-One.


Table of Contents:

  1. Vesa Cover Removal
  2. System Stand Removal
  3. Rear Cover Removal
  4. Memory Removal
  5. Optical Drive Removal

1. Vesa Cover Removal

1. Pre-Removal Instructions Before removing the Vesa Cover Removal:

  • During installation or removal of any hardware always ensure all data is backed up properly
  • Disconnect any telephone, network, or USB cables from the computer
  • Disconnect the computer and all attached devices from their electrical outlets

2. Establishing image.



3. Gently push the cover to open the vesa cover.



4. Remove the cover.



5. Complete.




Back to Top


2. System Stand Removal

1. Pre-Removal Instructions Before removing the System Stand Removal:

  • During installation or removal of any hardware always ensure all data is backed up properly
  • Disconnect any telephone, network, or USB cables from the computer
  • Disconnect the computer and all attached devices from their electrical outlets
  • Remove the Vesa Cover

2. Establishing image.



3. Use a Phillips head screwdriver to remove the four (4) screws securing the stand to the system.



4. Remove the stand.



5. Complete.




Back to Top


3. Rear Cover Removal

1. Pre-Removal Instructions Before removing the Rear Cover Removal:

  • During installation or removal of any hardware always ensure all data is backed up properly
  • Disconnect any telephone, network, or USB cables from the computer
  • Disconnect the computer and all attached devices from their electrical outlets
  • Remove the Vesa Cover and System Stand

2. Establishing image.



3. Use a Phillips head screwdriver to remove the four (4) screws securing the rear cover from the system.



4. On the back panel of system, there are 2 holes where u can insert your finger to gently push out the rear cover from the system.



5. Complete.




Back to Top


4. Memory Removal

1. Pre-Removal Instructions Before removing the Memory Removal:

  • During installation or removal of any hardware always ensure all data is backed up properly
  • Disconnect any telephone, network, or USB cables from the computer
  • Disconnect the computer and all attached devices from their electrical outlets
  • Remove the Vesa Cover, System Stand and Rear Cover

2. Establishing image.



3. Gently remove out the memory cover.



4. Pull the pin outwards to release the memory.



5. Pull out the memory.



6. Repeat step 2 to 3 for the next memory.



7. Complete.




Back to Top


5. Optical Drive Removal

1. Pre-Removal Instructions Before removing the Optical Drive Removal:

  • During installation or removal of any hardware always ensure all data is backed up properly
  • Disconnect any telephone, network, or USB cables from the computer
  • Disconnect the computer and all attached devices from their electrical outlets
  • Remove the Vesa Cover, System Stand and Rear Cover

2. Establishing image.



3. Remove 2 screws on the ODD bracket



4. Gently lift up the ODD (1) and remove the cables (2).



5. Complete.


Back to Top





Identificación del artículo: SLN295882

Última fecha de modificación: 05/17/2017 10:50 AM


Califique este artículo

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
No
Envíenos sus comentarios
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"
Disculpe, nuestro sistema de comentarios está actualmente inactivo. Vuelva a intentarlo más tarde.

Muchas gracias por sus comentarios.