Consulta de temas

How to Replace the Fusing Unit on the C2665dnf Dell Laser Printer


Table of Contents:

  1. Removing The Fusing Unit
  2. Installing A Fusing Unit

This article provides information on "How to Replace the Fusing Unit on the C2665dnf Dell Laser Printer"

Replacing the Fuser on C26xx and C37xx Printers (01:03) - English Only


1. Removing The Fusing Unit

  1. Turn off the printer and wait for 30 minutes.
  2. Push down the latch toopen the rear cover.

  3. Grasp the grips on both sides of the fusing unit squeezing the lever under the left side grip, and then pull out the unit.

More info can be found in the C2665dnf User’s Guide.

Back to Top

2. Installing A Fusing Unit

  1. Unpack the new fusing unit.
  2. Make sure that the two tabs of the fusing unit align with the grooves on the printer, and then insert it into the printer until it clicks.

  3. Close the rear cover.

Note: After replacing the fusing unit, be sure to initialize its life counter by following the instructions in the accompanying manual.

More info can be found in the C2665dnf User’s Guide.

If these steps do not correct the problem, please contact Dell Technical Support.

Purchase Toner and other xxxx Dell Laser Printer Supplies

Dell Recycling

Back to Top



Identificación del artículo: SLN286264

Última fecha de modificación: 04/04/2016 09:45 AM


Califique este artículo

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
No
Envíenos sus comentarios
Los comentarios muestran caracteres no válidos, los caracteres especiales que no se aceptan son <> () &#92;
Disculpe, nuestro sistema de comentarios está actualmente inactivo. Vuelva a intentarlo más tarde.

Gracias. Sus comentarios se han enviado.