Knowledge Base

What tape devices are supported in a Storage Area Network (SAN) environment using a Dell™ PowerVault™ storage device? - Technical Tip - 161861


What tape devices are supported in a Storage Area Network (SAN) environment using a Dell™ PowerVault™ storage device?

In order to attach a SCSI tape device to a Storage Area Network (SAN), you must use the Dell™ PowerVault™ 35F bridge for the connection. The PowerVault 35F only supports High Voltage Differential (HVD) devices, therefore you must use HVD tape solutions in a SAN Environment.

Supported

  • PowerVault 130T DLT Tape Library
  • PowerVault 120T DLT 4000 Autoloader
  • PowerVault 120T DLT 7000 Autoloader

Not Supported

  • PowerVault 120T DLT1 Autoloader
  • PowerVault 120T DDS3 Autoloader
  • PowerVault 120T DDS4 Autoloader



 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: SLN108896

Last Date Modified: 11/14/2010 12:00 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Feedback shows invalid character, not accepted special characters are <> () &#92;
Sorry, our feedback system is currently down. Please try again later.

Thank you. Your feedback has been sent.