NOTE: Installation order is very important - use the following procedure, including reboots or the software will not function properly: 1. Download the CV_WBF_Setup_2690H_32bit_ZPE software package and install in the order listed below: a. Install Microsoft VC++ Runtime (2008 SP1) Libraries from the internet link:  http://www.microsoft.com/en-us/download/details.aspx?id=5582 b. Dell ControlVault Windows Biometric Framework Driver i. Go to the C:\dell\Drivers\XXXXX\Dell ControlVault WBF Driver\USH folder and double click on CVHCI.msi and follow the wizard installation instructions until completed. ii. Reboot c. Dell ControlVault WBF Firmware i. Go to the C:\dell\Drivers\XXXXX\Dell ControlVault WBF Firmware\firmware folder and double click on the ushupgrade.exe and follow the wizard installation instructions ii. In the pop up dialog window press the Start button iii. When installation is completed press the Restart button. The system will reboot. 2. Enable ControlVault Windows BiometricFramework feature (Start->All Programs->Broadcom->USH Tools and click on ControlVault WBF a. In pop up dialog window select Enable and the press the Set button. b. Press the Exit button c. Allow time for any windows updates to complete 3. Steps to run Fingerprint Management Application (FMA) User Interface: a. Go to Windows Start->Control Panel->Hardware and Sound->Biometric Devices  b. Click on Change biometric settings c. Select Biometrics on settings  d. Choose Allow users to log on to Windows and domain e. Press Save Changes button f. Click on Use your fingerprint with Windows g. Follow wizard installation instructions to enroll your fingerprints(s) h. Begin using fingerprint authentication feature by selecting the Fingerprint emblem at Logon. The first time it will ask you to enter your password to verify authentication. Thereafter you can use just the fingerprint to logon. A slow finger swipe is recommended. It may take a few seconds to fingerprint authenticate.