Dell Workgroup Laser 5210n, v.E211, A03

Engine firmware update for Dell Mono Laser 5210N

Version

  • Version E211, A03

Compatibility

Compatible Systems
Supported Operating Systems
  • MS Windows 98
  • MS Windows Vista 32-bit
  • MS Windows ME
  • MS Windows Server 2003
  • MS Windows NT 4.0
  • MS Windows 2000
  • MS Windows Vista 64-bit
  • MS Windows XP
  • MS Windows XP x64

Applies to

5210 Mono Laser Printer;

Date

Release date
20 Jul 2007
Last Updated
03 Nov 2011

Importance

Optional. Dell recommends the customer review specifics about the update to determine if it applies to your system. The update contains changes that impact only certain configurations, or provides new features that may/may not apply to your environment.

Available formats

File Format:Hard-Drive
File Name:LS_ST_E211_upd_eng.fls
Download Type:HTTP
File Size: 1MB
Format DescriptionThis file contains a compressed (or zipped) set of files. Download the file to a folder on your hard drive, and then run (double-click) it to unzip the set of files. Follow the instructions to complete the installation.
Added to download list
Go to [{0}]
To ensure the integrity of your download, please verify the checksum value.
MD5:
de24dfd2f061f98c0153476e92d77ce5
SHA1:
Not available
SHA-256:
Not available

By downloading, you accept the terms of the Dell Software License Agreement.


Fixes & Enhancements

- Added feature to allow disabling tray-linking
- Added feature to reverse the tray order during tray linking
- Address slight toner leak when the printer is first powered on
- Improved time-to-first-print for some printers at low AC line voltage
- Added feature to reduce "922.04 Service Fuser" error when the printer is operating below the proper temperature.

Installation instructions

Custom Instructions for LS_ST_E211_upd_eng.fls:

1. Download the firmware file and place it on a convenient location on your system, example, c:\LS_ST_E211_updeng.fls”.

2. Note the current firmware version of your printer. From the printer’s front panel, press Menu > Reports > Menu Settings Page.

3. Open a FTP connection to the printer. From the Windows’s Command prompt, type: FTP [ip address of printer], example, FTP 192.168.10.100.

4. After the FTP connection has been established, send the firmware file to the printer. From the command prompt, type: PUT “[path to the firmware file]” e.g. PUT “c:\LS_ST_E211_updeng.fls”.

5. The firmware update will take approximately one minute, do not power off or send print job to the printer during this time.

6. The printer will restart itself after firmware update has been completed.

7. The engine firmware version should now be “LS.ST.E211-0”. To confirm, go to either the printer’s EWS (Reports > Device Information) or print the Menu Settings Page again from the printer’s front panel.

My Download List-#1 (0 )

My download lists

My download lists enables you to create and save lists of drivers to install at a later time. Lists can only be saved by logging into your existing account or creating a new one, and selecting “Save this list.”
Learn more